Klickfix Fahrradkorb Lampen Halter / Klickfix Bikebasket Lamp Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lampenhalter für Fahrradkorb von KLICKfix / Lampholder for Bikebasket from KLICKfix
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 134
- Wydruki
- 0
- Wyświetlenia
- 1117
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Lampenhalter für Fahrradkorb von KLICKfix,
für Handelsübliche Lenkerlampen,
da der Korb vorne am Lenker die Lampe behindert,
habe ich einen Halter für den Korb entwickelt.
Dieser Lampenhalter ist so nicht zu kaufen.
Gedruckt wurde der Halter aus ASA, PETG sollte ebenfalls gehen, mit 0,4 Düse und 0,2 Schichthöhe mit Support.
Es werden 4 Schrauben M4 x 10 und 4 Muttern M4 benötigt, am besten aus Edelstahl.
Schraubensicherung wird empfohlen.
Dabei zu beachten ist, dass das Drahtnetz nicht symetrisch ist, was mir erst beim Zusammenbau auffiel.
Lamp holder for bicycle basket from KLICKfix,
for standard handlebar lamps,
because the basket at the front of the handlebars obstructs the lamp,
I developed a holder for the basket.
This lamp holder cannot be bought as is.
The holder was printed from ASA, PETG should also work, with a 0.4 nozzle and 0.2 layer height with support.
4 screws M4 x 10 and 4 nuts M4 are required, preferably made of stainless steel.
Screw locking is recommended.
It should be noted that the wire mesh is not symmetrical, which I only noticed when assembling it.