1 / 1
New Dice for Balance Tetris game by @Paulorfo — zdjęcie 1

New Dice for Balance Tetris game by @Paulorfo

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The original dice was too light - the new dice will accept a 1/2" ball bearing in the center and has printable faces

Ocena
0 / 5
Polubienia
8
Pobrania
28
Wydruki
0
Wyświetlenia
402
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I love the Balance Tetris game by @paulorfo. I wanted a better dice for the game so I created one. This dice accepts a ½" G25 ball bearing in its center to make for some heft. I also might have gone a bit overboard but created faces for each side of the dice to accepted 5mx5mm printed squares. I have also included a blank face that you can print in your shapes color and glue that to the dice face. Our family played the game with the new dice and it acts like a real dice. I did the project this way so those without MMU or multicolor can still have a multi-color dice.  Just throw a few squares on the print bed when you print the parts and you are good.. or use the blank face and print a color “coin” for each side of the dice.

The ball bearings can be grabbed here: https://www.amazon.com/dp/B07CHSGGKK

PS. This is a great challenge to see how well your first layer prints - the small squares are 4.9mm x .60mm, the dice faces are .8 total but first layer is .2 to accept the printed squares. 

 

Tagi