BD-1 Shoulder Mount Insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my solution to mounting BD-1 to my shoulder for a Cal Kestis costume.
- Ocena
- 0 / 5
- Polubienia
- 57
- Pobrania
- 84
- Wydruki
- 0
- Wyświetlenia
- 2088
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Cosplay & Costumes in general
- Licencja
- Creative Commons — Attribution — Noncommercial
This model is my custom shoulder mounting solution for my BD-1. It is based on a droid model from a seemingly-obsolete seller, 3DPRINTSTUDIOEK on Etsy. I wish I could link to the exact BD-1 STLs I purchased, but it appears that they are no longer listed.
This mounting solution relies on a shoulder mount I purchased on Amazon. However, it will easily interface with any 1" ball joint / RAM mount.
Be sure to print this horizontally to ensure the neck's layer lines don't break apart from the weight of the droid, as seen below:
Printed on my MK4 with Prusament PLA. I ended up going with nearly 100% infill to ensure highest strength, but it likely didn't make much of a difference compared to 25% infill (but my shoulder sure felt it)