MagSafe iPhone Watch Stand V3

Update: 02/09/2025 Added V5 models that is compatible with non-OEM MagSafe puck (Amazon link).

Update: 12/22/2024 There is a V4 model that supports the new MagSafe puck which has a slightly different footprint.  If your puck has a braided cable, V4 is the model you want.

Update: 11/13/2023 I took a couple millimeters off of both the left and right side and shifted the iPhone charger hole up by one and a half millimeters based on some feedback from someone whose iPhone 15 Pro case didn't quite fit. 

Update: 11/05/2023 Some very old Apple Watch chargers have a MASSIVE USBA connector and I didn't plan the V2 channel out to support that type.  The V3 model will support it.

This stand fits the MagSafe and Apple Watch chargers.  If you have some AirPods you also want to charge, check out my latest model that charges all 3!  Both charger cords should be fed into the stand from the front/top and then guided down the channels.  The cord channels on the bottom of the stand are different sizes because the cords are different sizes.  The phone cord should be routed directly down the smaller channel and the watch cord in the larger channel.

This was printed on a Prusa mk3s.  There is very little tolerance in the spots where the chargers fit and the cord tracks as I didn't want them to come loose.  Feel free to scale the model if your charger(s) do not fit.  I recommend at least 0.15 resolution and whatever infill you want.  Print it on its face so you don't need supports.  There will be some bridging on the parts of the print that are hidden after the MagSafe charger is installed.