1 / 5
Boss RC-10R Mounting Plate — zdjęcie 1
1 / 5

Boss RC-10R Mounting Plate

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Attach the RC-10R to a pedal board with Velcro without sticking Velcro to the actual pedal.

Ocena
0 / 5
Polubienia
1
Pobrania
20
Wydruki
0
Wyświetlenia
286
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

While based off a concept found in the linked model, I built this model from the ground up myself in Fusion 360. Instead of the mount attaching to a Rockboard pedal board, this one is a flat bottom with the intention of sticking Velcro to it to attach to any pedal board. This allows attaching the pedal using velcro but not having to stick it directly to the pedal.

The mount attaches to the RC-10R pedal with four existing screws on the pedal. The screw holes are recessed so the original screws can be used.

I added a cutout on the rear side so that the serial number and model can be seen when mounted on the pedal.

Use support for the bottom screw holes. Don't use support for the rear screw holes. Organic supports worked well, and were easy to pop out after printing with an appropriately sized hex wrench.

Printed 10% infill, added a few extra perimeters over default.

Tagi