1 / 7
2040 Filament Spool Mount Longitudinal Mount for 4" Bearings
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Filament holder for 3D printers mounted Longitudinal to the 2040/2020 v slot rail.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 135
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A Longitudinal mounted Spool holder with filament routing. For those really tight enclosed printers where mounting the filament spool in the traditional manner would take up way too much space. Low resistance smoothest rotation. The models included modeled threading for M4 screws.
Requires:
- 4"/120mm Lazy Susan bearings
- M4 Screws (Flat Socket heads)
Instructions:
- Dismantle the Lazy Susan bearings so the counter sink holes are on the same side.
- Remove the bearings using the exit hole on the side.
- Use a magnet to draw out the bearings.
- Degrease the rings and the bearings
- Use lithium grease for the bearing race ways on the rails.
- Reassemble the Lazy Susan (make sure the countersink holes are on the same side)
- Put bearings back into the Lazy Susan and cap the exit holes with the provided grub screw