1 / 4
Part Cooling with Neopixel
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a part cooling system made by this guy along with my approach on hotend Neopixels.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 151
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Info
This is a part cooling system made by this guy along with my approach on hotend Neopixels.
You will need
- 5 Neopixels similar to this one - Single Breakout Neopixel
- a motherboard that can support Neopixels
- Soldering Iron
- a 3-wire ribbon cable with a connector to fit your motherboard
- ready to tweak some firmware stuff
- Insulation tape
Installation
- On the blower side, you screw it to your blower fan, the same way the stock blower vent is installed.
- On the other side, it holds to the fan box with a small chamfer, make sure to slide it in.
- The leds are seated into their slots and then soldered with small wires . You can even hot-epoxy glue them to the printed but, but this makes it impossible to transfer them to a new print.
- Cover the wires with some insulation tape. The fan box is metal and could short your leds.
- If you are using Skr e3 mini you have to change a small jumper on the motherboard to power the leds. Here is the SKR documentation that shows the jumper.
Firmware
- I am using marlin and i had to enable neopixels and flash again
- If you are using an SKR mini e3, you can follow this github solution to get the leds working. This solution implements this improved Neopixel library
Designed in
Firmware
Hardware
- Ender 3 Pro
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
25%+
Filament: Devil's Design PLA, ABS, PETG Black
Category: 3D Printing