1 / 11
PiSCSI Macintosh SE and SE/30 Expansion Slot Bracket — zdjęcie 1
1 / 11

PiSCSI Macintosh SE and SE/30 Expansion Slot Bracket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A bracket to install a Raspberry Pi and PiSCSI in a Macintosh SE or SE/30 expansion slot.

Ocena
0 / 5
Polubienia
12
Pobrania
174
Wydruki
0
Wyświetlenia
1957
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

The PiSCSI is an exciting project by the retro Mac community, which turns a Raspberry Pi into a virtual SCSI device. It can host virtual hard drives and CD-ROM drives, which can all be attached and detached through a web interface hosted on the Raspberry Pi itself. Soon, the PiSCSI might also function as a virtual Ethernet adapter, simultaneously solving the storage and connectivity problems of 68k Macs!

This bracket mounts your Raspberry Pi and PiSCSI in the expansion slot on your Macintosh SE or SE/30, so your RaSCSI can be permanently installed inside your Mac. You can use the PiSCSI for hosting virtual hard disks, hosting virtual CD-ROM drives, and for network connectivity through the emulated Ethernet adapter. Power can be provided by the power supply on the Macintosh. The PiSCSI is controlled via web browser on another device (another computer, phone, or tablet).

Parts

To install your Raspberry Pi and PiSCSI in your Macintosh SE or SE/30, you'll need:

  • x2 M3 screws (at least 6mm long)
  • x2 M3 nuts
  • x4 M2.5 11mm standoffs
  • x4 M2.5 screws
  • x1 Molex power cable (recommended cable)
  • x1 SCSI ribbon cable (unfortunately, the original cable is too short)

Installation

If you build your own PiSCSI, you can omit the microUSB port, as well as the DB-25 port to streamline the assembly process (or you can leave them installed).

To power the PiSCSI, I recommend cutting the end off a Molex power cable (leaving the male plug/female pins side), removing the +12v (yellow) wire and adjacent ground (black) wire, leaving just the +5v (red) and ground (black). Then, solder the red wire to the the 5v through-hole on the PiSCSI, and the black wire to the GND through-hole.

You can plug the Molex connector into the hard drive power connector on your Mac.

Release Notes

v1

  • Initial release

v2 (2024-04-01)

  • No changes to models
  • Removed 1.0 models (they no longer serve a purpose)
  • Updated license from non-commercial/no derivatives to a more permissive license
  • Uploaded .F3D and .STEP files

Tagi