1 / 2
ICStation 4x 18650 Power Board Cover GY19481
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bottom cover for the ICStation 4x 18650 Power Board model GY19481-2. I was afraid of shorting things out when using.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 184
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
You can print as is with no supports needed. I would suggest 3 walls minimum as I don't have any pillars for screws (not that advanced yet in design). I used clear PETG so the lights on the bottom can shine through. Just used a little drill bit to make holes for the screws. Screws were just salvaged ones from another device, so I can't tell you anything specific about them.
Here is a link to the item: https://www.icstation.com/product_info.php?aid=527&products_id=15843
