Air Filter with activated carbon/ Aktivkohle-Luftfilter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an airfilter for using with enclosed FFM printers.It helps reducing the malodour during printing e.g.ASA a lot .
- Ocena
- 5 / 5
- Polubienia
- 37
- Pobrania
- 232
- Wydruki
- 4
- Wyświetlenia
- 1853
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
BOM
2x printed part "Luftfilter.stl"
1x printed part "Luftfilter_Case.stl"
4x Panhead screws 4.5mm or 5mm diameter, length depends on the fan width
1x Fan 120mmx120mmx38mm or 120mmx120mmx25mm, 12V or 24V, high pressure model highly recommended
2x woven filter medium, mesh size just small enough so that the granules do not fall through
enough granulated activated carbon (3,5mm...5mm granularity) to fill the case
Assembly
See picture
Hint: Cut the woven filter medium a little bit larger than the inner diameter of the air filter case. Put one filter medium in the case and fill it fully with granulated activated carbon. Put the second filter medium on the activated carbon.
Print Settings
Rafts: No
Supports: No
Resolution: 0.2
Infill: 10%
Filament: eSun PLA+ Dark Blue