Replacement bearing hub for VEVOR pottery wheel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement bearing hub for a VEVOR (and endless other crap brands) pottery wheel.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 452
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
This is a replacement bearing hub for a VEVOR branded pottery wheel. The same pottery wheel is sold under countless other brands on Amazon/Aliexpress/wherever, and obtaining replacement parts for this wheel is impossible.
Re-use the bearings from the old hub. Depending on your 3D printer, you may find the bearing holes are loose or tight. If they're tight, sand them out a little. If they're loose, use epoxy to glue them in. You may also have to drill out the hex bolt holes.
Ensure that the motor pulley and big pulley are aligned when you've got the machine apart - when I was repairing this machine, I had to flip the drive pulley over on the motor. Otherwise the drive belt will rub against the edges of the pulleys, and might ride up on the lip of the big pulley - this is likely what caused the broken bearing hub. It can't be understated how much of a piece of trash this wheel is :)
Print Settings
Printer:
Homemade i3 clone
Rafts:
No
Supports:
No
Resolution:
0.25mm
Infill:
35% cubic
Filament:
Eureka Filaments PLA
Notes:
I use a 0.5mm nozzle, 0.25mm layer height, 4 outside perimeters, and 6 top/bottom layers.
Category: Replacement Parts