Gridfinity small SMD Box with lid

I needed storage for SMD components and looked for any Gridfinity compatible Boxes with lids but didn't find anything. So I took matters in my own Hands ande here we are.

I printed mine with 0.2mm layer height and a 0.4mm nozzle, no support needed.

Tolarances can be a little tight but a little bit of movement made the lids easy to open but not too easy so they open by themselves.

For installing the lids i have added a small notch at the outer side of each compartment, so align the ball to the inner side first, then rotate the lid into position (see picture).

There are two different Lid models now. They should both fit for all the Boxes, the second one has a bigger notch for better grip with a finger but it takes up a little space inside the container. 
If its really hard to open the container for you, you can try to shave off the spheres at the front of the lid (near the notch, the back ones work as the hinge). This also leads to the lids opening by themselves easier though (if they fall down for example).

To the people who downloaded V5 of the Boxes:

I was made aware that there was a  misalignment error in V5 that offset the holes for the magnets, this is fixed for V6!
The Lid V5 and V6 should still be the same, so no need for reprinting (if you wanted to do that)

Changelog

• 2023.11.02 Added 3U and 4U variants of both non- and stackable versions