Dominion Lazy Susan - sized correctly & cut

This is for the card game Dominion, by Rio Grande Games. It's a large (~60cm in diameter) tray designed to be place on a "lazy susan" base so all players can spin the tray and reach all the cards easily. It can hold both sleeved and unsleeved cards, although the sleeved cards may be a little tight along the outside, depending on the sleeve type. There are also 20 “kingdom card” locations along the outside, which should be plenty for any additional “Adventure” or other special cards beyond the normal 10.

The tray has been cut to fit the 210mm x 210mm bed of the Prusa MK3S+ but should work on any bed that size or larger. I recommend printing with a brim to reduce the chance of warping, but some of the models don't have much room for a large brim. Use your best judgement.

FYI, the tolerances are VERY tight, to the point that I had to file a few pieces and use a “persuader” (aka, rubber mallet) to get them to fit. This is my first time using dovetail cuts and they came out tighter than I was expecting.

The file dominion-lazy-susan is simply the enlarged, uncut file for reference. Also, the .stl files do not contain the coordinate markings, but the file names indicate which pieces are attached where in the entire wheel.

Note: I had the NW marking floating too high to print in this test, but it's fixed in the uploaded model. Also, I ran out of the color I was using more than once so my copy has this patchwork look. 

Improvements could be made by adding magnets or pins to the outside/corner pieces (NW, NE, SW, SE) to get them to connect to the center E/W pieces better. Also, loosen the tolerances just enough to make assembly & disassembly easier.