VanMoof X3/S3 kick lock cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A kick lock cap for the VanMoof, to avoid triggering it when the bike is stored indoors or is in for a repair.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 68
- Wydruki
- 1
- Wyświetlenia
- 619
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a kick lock cap for the VanMoof, to avoid triggering the lock when the bike is stored indoors or is in for a repair. The cap is a friction fit and simply clips over the lock. The cap has been tested on both an X3 and S3. The fit is quite tight to ensure it doesn't drop off – it went on a half hour bike ride without falling off. It's probably best printed in PETG to give some flexibility, but PLA should also work thanks to the thinner design of the clip-over part.
You need to print this part with support. Support is only needed for the bottom half (see included screenshot).