1 / 2
Re-Remix-All in one - Filament Jam - Cleaner & Runout Sensor (Modified 12/21) — zdjęcie 1
1 / 2

Re-Remix-All in one - Filament Jam - Cleaner & Runout Sensor (Modified 12/21)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

December 2021 Change: Added clamp for Bowden/PTFE tube on outbound side to make it easier for filament to glide over…

Ocena
0 / 5
Polubienia
13
Pobrania
39
Wydruki
0
Wyświetlenia
441
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

December 2021 Change: Added clamp for Bowden/PTFE tube on outbound side to make it easier for filament to glide over jam sensor. INSTALLATION TIP: Install the electronics before the PTFE/Bowden tubes. Make sure the switches clear the housing and the tubes before tightening everything down.

This is a Re-Remix of the excellent combo filament run-out and jam sensor (also filament cleaner, but I don't use this feature).

Minor changes in this version:

  1. Moved the mounting holes to be clear of the filament path and wiring.
  2. Made the wiring holes slightly larger, and also added a recess if you want to have the wiring come out the front. This makes adding the wiring much easier - the wired harness just drops in rather than having to be soldered into the assembly.
  3. Added a clamp for a PTFE/Bowden tube to feed the filament right to the edge of the upper roller switch for more reliable alignment.

These are the switches I used: https://www.amazon.com/dp/B00MFRMFS6?psc=1&ref=ppx_yo2_dt_b_product_details

Connectors: https://www.amazon.com/dp/B08JCRH8J7?psc=1&ref=ppx_yo2_dt_b_product_details

or https://www.amazon.com/dp/B07CTH46S7?ref=ppx_yo2_dt_b_product_details&th=1

depending on the printer you are using and the size/number of conductors for the switch.

I have added a wiring diagram for a 2-conductor switch connection.

 

Category: 3D Printer Parts

Tagi