1 / 5
简约色板(填充样品) Simple filament swatch(Infillsample) — zdjęcie 1
1 / 5

简约色板(填充样品) Simple filament swatch(Infillsample)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

设计干净简约的耗材样本卡片和填充样品卡。 Clean, minimalist design of filament swatches and infillsamples.

Ocena
0 / 5
Polubienia
11
Pobrania
51
Wydruki
0
Wyświetlenia
391
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Test Models
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

您好,如果您打算下载此模型,请考虑留下赞、发布制作、留下评论甚至捐赠。谢谢!

Hi There, if you plan on downloading this model please consider leaving a like, posting a make, leaving a review, or even a donation. Thank You!

 

你可以通过制作简单的色板来确认所选耗材的质量或者在不同厚度情况下耗材的透光效果。

You can confirm the quality of the selected filament or the light transmission of the filament at different thicknesses by making a simple filament swatch.

 
我找遍了类似网站,始终没有找到一款能令我完全满意的色板,所以我亲自操刀设计了这款简约风格的色板。我在色板的长宽数值上使用了黄金分割比1:0.618。据我所知这个比例被公认为是最能引起美感的比例。
I searched through similar websites and couldn't find a swatch that I was completely happy with, so I designed this minimalist swatch myself. I used the golden ratio of 1:0.618 for the length and width of the swatch. As far as I know, this ratio is recognized as the one that evokes the most aesthetic sense.

 

我使用了5种不同厚度的设计,从0.4mm-2.0mm的5种厚度,每次递增0.4mm。

I used 5 different thickness designs, from 0.4mm to 2.0mm in 5 thicknesses, with each increase of 0.4mm.

 

建议使用0.4mm打印头,打印层高为0.2mm

It is recommended to use a 0.4mm printhead and print with a layer height of 0.2mm

 

你可以在不使用任何额外支撑的情况下完美的打印所有模型。

You can print all your models perfectly without using any additional supports.

Tagi