Big Einsy MMU+
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Big Einsy Case with MMU cable entry along the frame side and various other tweaks. Includes STEP file.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 86
- Wydruki
- 2
- Wyświetlenia
- 804
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My MK3S developed the “XFLASH is not responding” problem, so I had to replace the Einsy. Since I was going to be tearing it all apart, I decided to create my own version of Boogie's Big Einsy Case with an MMU cable entry port along the frame side and various other tweaks.
My remix is based on Boogie's 20.04.23 version, with the following modifications.
- Added entry port and cable space on right for MMU support.
- Added slide on frame mounting holes.
- Moved mounting location down by 1cm
- Added a tab to attach to a T-Nut in the bottom frame to reduce vibration.
- Opened up main cable channel guides.
- Enlarged heat bed cable hole slightly.
- Reoriented square nut holders to make inserting them easier.
- Includes a STEP file with all parts.
Printing the slide-on mounting hole slots likely requires supports. I used paint-on snug supports for the 4 holes, and have included a PrusaSlicer project with supports enabled.

The same nuts and screws are required as are for the original. The MMU cable port is clamped by the cover and does not require additional screws.
If you intend to fully tighten the top screw on the print bed side, you need to do it before installing the Einsy or else you can't reach the head, even with a ball head driver. I left mine snug so it can just slide, and tightened the other 3 fully.
There are two holes for mounting to a T-nut in the bottom frame rail. One is 4mm to fit common T-nuts that I already had, and one is 3mm so you can use a spare 10mm m3 bolt. You only need to use one. If you do not have any T-nuts, there are printable models available. @Extrutim has published all plastic models in multiple sizes.
Due to the MMU cable area and rearranged cover mounts, cover remixes for the original do not fit my version.
Thanks:
In addition to Boogie's excellent model, I had inspiration from some other remixes.
Mounting slots inspired by https://www.printables.com/model/312064-big-einsy-case-mmu2s-clip-in-place-mk25smk3s, although mine are vertical rather than horizontal.
Opened cable trough inspired by https://www.printables.com/model/451000-big-einsy-case-easy-access
The included "Big Einsy Case cable cover 1" and “Big Einsy Case cable cover 2” models are unmodified from Boogie's version.
I use MMU2S cable clip by MP to attach the MMU cable to vertical frame.