79-80 RX-7 two pin Hood Emblem 8871-51-771B
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement hood emblem for a 1st gen 79-80 rx-7.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 157
- Wydruki
- 0
- Wyświetlenia
- 479
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Replacement front logo for a 79-80 rx-7. I designed this to mount using M3 machine screws rather than pins. This not only makes the print much easier, but it also prevents the downsides of having flimsy 3d printed plastic pins to mount with. that being said you can also use silicone or other adhesive to install this without the screws.
Please note this is not a direct recreation while it is close there is some minor differernces with the original.
In addition, I wouldn't recommend using 3d printed parts on your car please do so at your own discretion.
Screw Mounted install:
- 2x M3 x4mm machine screws.
- 2x brass m3 heat set inserts.
Using a soldering iron press the heat set inserts into the two holes on the back of the emblem. get them as flush as possible without poking them through the front. Reach up under the front of the car and thread the M3 screws into place.
I would HIGHLY recommend this be printed in ASA.
Note: This model is provided free of charge by me, and I do not and will not profit from this in anyway. Mazda is trademark of Mazda Motor Corporation, and I am in no way affiliated with them. This part is no longer manufactured by Mazda and is only available from third parties such as Ebay. So, I provided this as a way for people to replace broken or missing emblems without shelling out a bunch of money for used/nos parts.