Peanut The Chef Otter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cute isometric otter model by sch0i on sketchafab
- Ocena
- 5 / 5
- Polubienia
- 28
- Pobrania
- 123
- Wydruki
- 2
- Wyświetlenia
- 681
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Characters & Monsters
- Licencja
- Creative Commons — Attribution
General Info
I am experimenting with exporting traditional polygonal models for 3D printing. I found an excellent otter model on Sketchfab that I wanted to share for others to print. I've added a base platform to the model because the feet are not flat; however, I had trouble supporting the hilt of Peanut's sword, and it broke off—perhaps you might have better luck. Additionally, I included a version without the base, in case you prefer it that way. Without the base, it will rest on the tail, as seen in the image.
Printing
Supports: This print requires a lot of support, especially for the arms, sword, and apron areas. They were kinda of a pain. On Bambu slicer I used a grid rectilinear pattern at a threshold angle of 15° and a top Z of 0.3mm.
Adhesion: If your print bed is clean and well-leveled, you should be fine without any brim, though your mileage may vary.
Other than that, the rest is up to you. I printed this mostly with the standard Bambu PLA profiles, and it turned out great :).
Recommended print settings & machine info
| Material | PETG, ABS, or ASA for best results I used PLA |
| Layer height | 0.2 mm |
| Infill | 10-20% rectilinear |
| First layer speed | 90% of default |
| Supports | Yes |
| Brim | None (may be needed in case of poor bed adhesion) |
| Slicer Used | Bambu Slicer |
| Printer | Bambu P1P |
Additional Attribution:
Original Model Creator - sch0i
Sketchfab Model - Peanut The Chef Otterfolk_posed