Doorlatch for Thomson microwave oven
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Doorlatch replacement part for the locking mechanism of the Thomson combimat 25 oven door.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 311
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- GNU General Public License v3.0
Door latch for microwave oven Thomson Microwave Oven COMBIMAT 25. But I would not be surprised if it fits other models and brands as well since they all look alike. These door latches break off easily. Mine did as well and after numerous attempts to glue the original part I figured it was time for a replacement.
This piece is printed with minimal supports for the overhanging clips on top. No need to support the overhangs from the locking mechanism itself (so set your overhang threshold to 40 degrees or thereabout).
Created the part in FreeCAD. See attached files as well so adjust to fit your specific part! The part is simpler than the original which I think makes it even stronger. Only weak parts are the clips on top of the piece, they might break off (layers are easily separated on such a small item). So I added a little screw hole to tap in a small screw for extra strength.
Furthermore, it might be a bit tight so you might need to remove some plastic below the clips with a sharp surgical knife or whatnot.
Details for printing
- Printed in PETG for its strength and durability at higher temperatures
- Flat side on build plate
- Printed on Prusa mini+
- 0.15 mm SPEED, slightly modified
- Infill 50% for strength
- 4x perimeters
- Overhang threshold 40
- Pattern spacing 3.5 mm