Ender 3 v3 SE Endoscope camera holder/mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
designed for the ender 3 v3 SE. Quick attempt
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 73
- Wydruki
- 0
- Wyświetlenia
- 725
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this quickly by combining modified versions of two STLs so that I could use my endoscope. It is not pretty but gets the job done, and pretty amazingly so far. No other files existed when I looked. I used the pen holder from a user on the Creality Cloud site and an Ender 3 S1 endoscope mount found on thingiverse. My camera is somehwere between 5mm to 6mm and fits with a little shimming from tape. The pen holder was used because it used the factory mounting points and factory shroud. I went ahead and added my gcode from where I printed it on my E3V3SE.
Sources:
Pen mount: https://www.crealitycloud.com/model-detail/64ff4c4ccb4802a2e7f3ee66
Endoscope mount: https://www.thingiverse.com/thing:5230476