Filament Connector Stand (Filament Splicer Stand)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stand for AliExpress filament connector for easier handling of connector and filament during splicing
- Ocena
- 4 / 5
- Polubienia
- 37
- Pobrania
- 196
- Wydruki
- 2
- Wyświetlenia
- 2169
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was inspired by Lemanito's Vit Sport Filament Connector.
But I bought the connector from AliExpress and had other magnets in stock
Parts required:
- Filament Connector: https://de.aliexpress.com/item/1005005743810577.html
- 2 Screws M4x60: https://www.schraubenking.at/M4-x-60mm-Zylinderschrauben-DIN912-Edelstahl-A2-P005546
- 2 Nuts M4: https://www.schraubenking.at/M4-Sechskantmuttern-DIN-934-Edelstahl-A2-P000448
- 8 Magnets 10mm x 2mm: https://www.magnet-shop.net/neodym-magnete/scheibenmagnete/scheibenmagnet-10.0-x-2.0-mm-n35-nickel-haelt-1-kg
I have included the links to give you an impression of the material I have used.
How did I print it:
- 1 Base, 2 Clamps
- see picture of printbed for orientation of the parts to print without support
- 0,15mm Quality @MK3
- PETG
- Infill 15%
Assembly tip for the magnets:
Staple the 8 magnets together to form a long rod. Then insert them one after the other into the holes of the clamps. Now turn the clamps over and press them firmly onto a table top.
Now distribute the remaining 4 magnets over the ones already pressed in. Place the clamps on top of the base part and press down lightly. Complete the entire insertion process again by pressing the base firmly on a table top.
This way, all the magnets have the same orientation and are flush with the surface.
I did not use any glue.
Fix the connector onto the base:
- insert the connector into the base
- run a piece of filament (or a small allen key) through the clamps and the connector to align them
- drill with a 4mm wood drill through the holes in the base through the connector. Make sure you don't tilt
- Insert the nuts into the base. If they fit too tight, screw them at least 10mm onto a M4 screw, put it into the hole, align the orientation of the nut and gently hammer it into the base
- Use screws and nuts to fix the connector in the base
Modifying the stand:
Feel free to modify the model of the stand to your own requirements.
If you have any ideas to improve the stand, the model, the instructions, my English, I kindly ask for feedback.
Do not hesitate to ask if anything is unclear.