LM358 OP AMP WLED LIGHT
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was fascinted about the "simple" OP amps. After making a smaller one, i thought one bigger as a lamp would be nice.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 196
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
You can print anything without support, if placed correctly.
Print the Pins upside down. you will need 4xPins_inside. Print the outside pin two times, than mirror the pin in the Slicer and print it also twice. Stick them with CA glue or what you want in the base, there is a line for easy alignement.
The top shell of the IC is made out of two components, so you can print the model in two colours if you want.
For the Light i choose WLED, because its easy, cheap and simple.
I use an ESP 8266 Vemos D1 mini (ali express ~1,80€), WS2812B LED strips (60 LEDS/M) and a small Power bank (Don't operate without observation, it generates heat, use at your own risk (; )
Look up on the very good WLED website for informations about wiring.