Soft Tape Measure holder - another remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My take on this awesome model
- Ocena
- 5 / 5
- Polubienia
- 31
- Pobrania
- 228
- Wydruki
- 2
- Wyświetlenia
- 1283
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I thought this was an awesome design but (probably due to my lack of skill) I couldn't get the snap-in-place mechanism to work; the pins kept breaking off - so I added a 16mm M4 machine screw for assembly instead. While I was at it I also did a few other minor modifications, like change the spooling grip, which I had to because of the screw.
The parts should be dimensioned so that you can simply tighten the screw & the spool will still spin freely. If it's too tight just put a paper “washer” or two between the parts :)
NOTE: The parts are huge; I prefer to downsize in the slicer.