1 / 2
Media/Mode Converter Organizer
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small housing for a media or mode converter. Can hold up to 4 devices and has channels for cable management.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 363
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
I got tired of media and mode converters being stacked on top of one another and the cables becoming a mess so I designed a small housing to organize them.
This organizer can hold four devices and the channels on the bottom can have cables with RJ-45 heads or smaller ran through them to improve cable management. Upscale the model if you want to run larger cables through the channels. Due to the heat these devices can give off, I designed vents and printed in PETG and have never had any issues.
My print settings used a lot of filament and took a long time to print. I recommend refining the settings to use less filament. This could likely be printed in PLA or PLA+ without any heat issues.
- - - - - - - - - - - - - - - - - - - - - -
Printer: Bambu P1P
Nozzle: 0.4mm
0.16 Optimal settings
Thick Bridges: Yes
Infill: 15%
Infill Pattern: Tri-Hexagon
Overture PETG
Time: ~10H 30M
Filament Used: ~355g
┏┓┓┏┏┓┳┓┏┓┓ ┏
┗┓┣┫┣┫┃┃┃┃┃┃┃
┗┛┛┗┛┗┻┛┗┛┗┻┛