VzBot235AWD Skirts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Skirtmod for VzBot235AWD to mount the power supplies on the underside of the printer.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 63
- Wydruki
- 0
- Wyświetlenia
- 610
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I designed these skirts in order to install my power supplies on the underside of the printer. The original feet were too low in order to fit them. All other skirt mods would need to be printed on a bigger printer. Therefore i designed the skirts in a split design. I connected the two parts of the skirts using glue and the connector pieces. For the connector pieces you need four M3 heat inserts per side and four M3x5 or M3x6 Screws. I tried to implement the design of the original VzBot parts. The front skirt is designed to have a 19mm push button switch installed. I printed the skirts in ESun ABS+ Purple and the corner pieces ins ESun ABS+ Black. I also added feet which i printed in TPU FilaFlex 82A. There are two versions the flat one is more stable and thinner and the round ones are a bit more wobbly.
Use default VzBot settings to print.
Parts needed (currently running without back skirt):
28 x M3 Heat Insert (4 per corner and 4 per skirt side)
12 x M3 6mm (connect skirts with connector)
12 x M3 14mm (connect skirts to corners)