Honeycomb pattern cups for HSW (25mm/50mm/75mm)

I've seen a few similarly design cups for the Honeycomb Storage Wall (HSW) wall but all of them are a little to flimsy for my liking and none of them seem to utilize the peg connector (I'm sure there are some) which is my preferred connector.  So I just whipped up a few of them for random sizes that I needed (25mm/50mm/75mm).  All of them are 75mm tall.

I'm adding my .3mf file but print with whatever settings you want but remember that you don't need supports on these.  If you need a specific size, I'm not going to hold you over the coals and only allow you to source the files from me.  Here's the link to the onShape file.

Here's the deal with the size of the hex peg.  The radius of the hex for the original HSW creator is 6.7.  Mine is set to 6.5 as the standard radius was just too much for some of the HSW walls that I have.  I think this comes down to the printer and settings that one might be using as I've had the same problem with some other peoples designs as well.  Then if you ever used another printer (I have 3 different printers) to print some of your other HSW walls, there are just slight differences all over the place.  But at 6.5, mine are fairly snug, not like super tight and have have another design that holds a tool head that's actually supporting a 10lb motor on top of it with just two pegs.  Moral - It's working pretty good for me.

Hence the reason for sharing out the onShape file.  If you look at the top of the onShape file there are 3 variables.  1 for cupDiameter, 1 for cupHeight, and one for pegRadius.  Those are really the only 3 things I ever change for my personal use.  If you find that you DO NOT need your pegs undersized like I do, bump it up to 6.7 to be exactly the same as the standard peg by the original creator and then Bob's your uncle.

Apologies to anyone who might have ran into any sizing issues.

Change log: 
(11/6/2023)
Adding - 61x40 and 61x20 sizes

(11/29/2023)
Adding some more notes and adding link to onshape.