Narrow Outer Shoulders for Carrera Slot Car Track by BobC_3d
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a re-upload of BobC_3d shoulders for use with the Carrera 1/24 (and 1/32) Digital/Analog track system.
- Ocena
- 4,8 / 5
- Polubienia
- 52
- Pobrania
- 495
- Wydruki
- 1
- Wyświetlenia
- 2711
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
I created a version of the “Narrow Outer Shoulders” for the Prusa Mini some time ago (https://www.printables.com/model/101956-r130-outer-shoulder-for-180x180-printbed) and printed quite some pieces since that day.
Now I do own a bigger printer and thought I could re-upload the files from BobC_3d from Thingiverse.
I designed these shoulders for use with the Carrera 1/24 (and 1/32) Digital/Analog track system. They are 49.5mm wide - exactly half the width of the shoulders available from Carrera. I wanted shoulders, but didn't want to use up the table space necessary for the 99mm shoulders from Carrera. These are a nice compromise. The Red Carrera track clips can be used to attach them to track and join the ends. The Carrera wall brackets (current "tape" style and older "liquorice" style) and my custom wall brackets (see my other things) all attach to these shoulders without issue.
The naming convention of the shoulders is similar to Carrera's, so R1-30 is a 30 degree shoulder for outside an R1. Note that the shoulders are intended to be used 2 per track section except for the R2-30 and the R4-15 which are one shoulder per corresponding track section. I've included 2 variations of R2 and R4 curves to accommodate smaller print beds. Those should accommodate most i3 sized printers. If the shortest arc of each radius is used, the longest linear dimension is 220.2mm to the ends of the outside arc - so you may need to orient diagonally across bed.
So far I've used the R2-30 and R1-30 shoulders, and they work great.
Hope you enjoy!
CORRECTION: I printed these at .3mm layer heights, track surface down, 2 bottom layers, 1 top layer and 25% infill using Honeycomb pattern.