1 / 3
CR-6 SE 6burner LGX Lite direct strain guage mount — zdjęcie 1
1 / 3

CR-6 SE 6burner LGX Lite direct strain guage mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of 6burner's base and Bondtech's LGX Lite perch to fit together and keep the extruder attached to strain gauge.

Ocena
0 / 5
Polubienia
8
Pobrania
29
Wydruki
0
Wyświetlenia
447
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I've used 6burner's lgx base but due to the way it is not attached to the strain gauge on CR-6 SE it was a source of many printing issues - including problems with non consistent auto bed leveling.

To resolve those issues the extruder needed to be attached directly to the strain gauge. I prototyped with the perch designed by Bondtech but it was a bit too short and the extruder was angled in such a way that it hit the cooling part fan.

I redesigned the perch and the base to fit each other and solve those issues.

There's no need for square nut as I noticed that the friction from the Bondtech's Hotend Mount Plate is more than enough to hold the whole thing.

On the photos you can see the Hummingbird Extruder which shares the mounting and form factor with LGX Lite.

Printing suggestions: 

  • Supports are only needed a little in the Perch model but not in the Base
  • I used PETG for Perch and PLA for Base but probably one could use PLA for both
  • At least 2 walls 
  • At least 3 top/bottom layers
  • 10%-15% infill

Tagi