Wall-hugger plant pot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a plant-pot that hangs over a stone wall (70mm thick) without any additional hardware.
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 638
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
This plant pot is designed to be hanged over a wall or separation between gardens. The wall thickness is 70mm. Other sizes can be made by scaling on the printer or by request.
It has drainage holes on 2 sides with a 2 cm rim, so some water can stay in there as reserve.
Printed in PETG, the 20 cm tall print will take between 22 (150% speed) and 40 hours (100% speed).
I used a 0.6mm nozzle, 0.3mm layer height, 3 or 4 top and bottom layers, no infill and 2 perimeters. The middle part needs to be supported and if you want it really beautiful probably have to use adaptive layer heights, however, as this part is resting on the wall and out of sight a little roughness is no problem.