Eibos Polyphemus Filament Dryer Handle & Expansion Corners
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A few replacement parts for the new Eibos Polyphemus dryer.
- Ocena
- 5 / 5
- Polubienia
- 53
- Pobrania
- 258
- Wydruki
- 3
- Wyświetlenia
- 1848
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I recently tested out the Eibos Polyphemus filament dryer and made a few replacement parts for it.
The handle included with the unit is two halves held together with a couple of small screws. It is functional but it feels a little flimsy. This is not a 1:1 of it but it is pretty close in a unibody design. I like the single piece much better.
Also, the corner pieces for my expansion kit where incorrectly sized. This meant I couldn't use the included screws and it didn't sit flush. I scanned the profile of the part then extruded it to be a few mm shorter so that it works as intended.
Both where printed out of PETG but this is not a requirement.