1 / 7
Top-plate Extension for Accante Creality Ender 3 S1 (pro) Housing — zdjęcie 1
1 / 7

Top-plate Extension for Accante Creality Ender 3 S1 (pro) Housing

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These plates are a replacement for the existing Accante housing top-lid solution

Ocena
0 / 5
Polubienia
8
Pobrania
39
Wydruki
0
Wyświetlenia
652
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

The Accante acrylic housing (see https://www.amazon.de/dp/B0BX755CN8, and https://www.amazon.de/dp/B0C49TFHMF, or https://accante.com/en/) is a wonderful extension for the Creality Ender 3 S1 and S1 pro. The standard solution from Accante includes a special sunken lid so that the filament spool fits on the standard arm. If you do not hang the filament rolls on the printer, but place them behind it, for example, or if you want better protection from printer noise and odors (with ABS printing), you can use this solution.

It is a modular system that can be printed on the print bed of an Ender 3.

The model is made up of two baseplates that replace the Accante cover solution. As an extension, there is a honeycomb plate that is attached under the back plate. This can be used to attach additional cameras, cable holders, thermometers or fans.

Basically, both covers are designed to attach 5mm thick felt plates (for improved noise insulation and sealing).

On the Fusion 360 model pictures, you can see the cover plates in green. The felt holders in yellow (optional if you use felt) and the honeycomb plate in white. If you use felt but don't want the honeycomb plate, you can print two more optional felt holders for the back plate.

Since no standard filament spool fits on the arm supplied by Creality with the plate, you have to place the spools behind (or above) the housing (for example in filament dryers), or you can extend the arm with the following model of mine: https://www.printables.com/de/model/633692-filement-extension-arm-for-creality-ender-3-s1-pro. The extension arm lifts the spool by 6cm. 

So you have a wide range of options for completely sealing the top of the housing. 

Print

I printed everything with eSun PLA+ 0.2mm layer. Except for the felt clip, everything can be printed without support. It makes sense to set the perimeters to 3.

Use M3 screws to connect the honeycomb and/or felt fixtures and fix the backplate to the housing. You need 4 to 8 ~5mm hot melt copper nuts. 

Tagi