Spacer for the Unitak3D Z axis linear rail kit sold on Amazon
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
On my Ender 3 Pro the black aluminum spacers are a fraction of a millimeter larger than the hole for the eccentric nut…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 76
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
On my Ender 3 Pro the black aluminum spacers are a fraction of a millimeter larger than the hole for the eccentric nut in the back plate. The other 4 holes are fine just the two for the eccentric nuts might be a problem. I decided to make a part that fits over the two spacers and should keep them from popping through.
Mine was printed in ABS, PETG should work too but avoid PLA since it is affected by heat and tends to creep. After they are printed start the aluminum spacer into it and finish by squeezing it in a vice or small press. Print at 100% infill, no supports are needed.
Print Settings
Printer Brand:
Creality
Printer:
Ender-5 Plus
Rafts:
Doesn't Matter
Supports:
No
Resolution:
Any
Infill:
100%
Filament: Any ABS, ASA, PETG, PC Any
Notes:
Avoid makinf this in PLA since it will creep. Others will too but should not have a problem in this application.
Category: 3D Printer Parts