1 / 3
Laser Cutter Ramp Test Jig
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 0 to 45mm ramp test to get the perfect focus height for your laser cutter/engraver
- Ocena
- 5 / 5
- Polubienia
- 48
- Pobrania
- 549
- Wydruki
- 0
- Wyświetlenia
- 1731
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 5)Remiksy (0)Kolekcje (57)Powiązane
Simple test rig to get the optimal focus height of your laser cutter.
Instructions:
- Cut/engrave the SVG file on any 3mm material (red = cut, black = engrave, blue = fill). Make sure that everything is scaled properly (refer to the dimensions shown in the pictures, the width of the support should be 56mm). You can also 3D print the support using the Support.stl file, in this case you'll still have to cut/engrave the card part.
- Build the support (do not glue the card/top part)
- Place the support on your laser cutting bed
- Place the card on it
- Make it so the bottom part of your laser head barely doesn't touch the highest point of the card. You can also use a feeler gauge if you are afraid of it hitting the card while it's moving, in this case don't forget to add its thickness to the end result.
- Create a 180mm line in your laser cutting software and make it go from the highest point of the card to its lowest point
- Engrave it
- Check where the engraved line is the thinnest: this is your optimal focus height