StoneWall Zen Garden with water canal Pending Pegless Update!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Zen Garden with stonewalls, water canal and a Torii gate.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 73
- Wydruki
- 0
- Wyświetlenia
- 497
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
NEW: I'm getting rid of the pegs, I made an Ibeam system that is backwards compatible with this system so anything already printed, including bed, can be used.
Making a wooden wall and new stone wall versions, prototypes are being given to 2 different people to iron out bugs. (1/7/2024)
Added peg measuring tool to verify which size pegged wall you need, also added .96mm to the walls so they would fit closer together. 11/12/23 2:56am AZT
Side note, since I had to break it into parts, its now fairly modular, uses 4mm dowel system. (cutout 4.2mm diameter to make sure they fit.)
Current:
Please print base first, then try either the 4_8mm wall, or 4_2mm wall, I'd stop them after they got past the base for the first test to see which one fits better. I use a .8mm nozzle, so seams are a thing. If any of the three includes sizes don't work (to tight/to loose etc) put in the comments and I'll make adjustments and put up another variant.
I've added a v2 of the River bed left/right pieces that adds a thicker support piece behind the top of the Kanji disk. Likely because I'm using an .8mm nozzle it was to thin for it to print out properly without it, but left the original for those using a smaller nozzle to try.
Directions:
Base first, once wall determined (if settings are right, probably be the smallest one) print 14 walls. I've verified the river beds fit to each other, but you'll want to put a layer of rubber cement on them before attaching if you want it to hold water. I meant it to fit 3 middle river beds, and each side, but looking at it to print, I'm not sure it will fit. if not, leave on out, and fill the space between it and the walls with sand with everything else.
The tori just stands on the post in front of the gate opening, and the bridge on the sand.
bridgeBoard.stl X 8
bridgeSidev2.stl X 2
riverBedRight.stl X 1
riverBedLeft.stl X 1
riverBedMiddle.stl X 2
riverBedCenter.stl X 1
Selected Zen Garden Wall X 14
ZenGarden1v2BareBonebase.stl X 1
Torii.stl X 1
Putting together:
The walls will snap on to the pegs,
Click the riverBedMiddle and Center pieces together in any order, with the Left and Right segments on the end to fit it in the orientation you see in the render, for the other direction substitute the Center piece for another middle piece for a closer fit. To waterproof you'll want to coat both sides with rubber cement before you click them together.
The bridge, shove each board through a slot on one side all the way through, then push it into the other side, and continue with all the boards. avoid the 2 end pieces till the end.
the Torii Gate goes on the two platforms at the gate entrance. then fill the base with sand on either side of the canal to be level with the top of the base, and place the bridge going over the canal.
I've really enjoyed making this, and will be making accessories to compliment it, totally for taking any suggestions on what to add.
