1 / 9
ZK-4KX (XK-4KX) Power Supply Portable (cheap and easy to make!) — zdjęcie 1
1 / 9

ZK-4KX (XK-4KX) Power Supply Portable (cheap and easy to make!)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple ZK-4KX-based lab power supply. Easy to print, just a few cheap parts to buy.

Ocena
0 / 5
Polubienia
13
Pobrania
73
Wydruki
0
Wyświetlenia
644
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Portable and lightweight DIY power supply with 5-30V input and 0.5-30V, 4A output.

Parts to buy.

  1. ZK-4KX (XK-4KX) Buck-Boost converter (71.6/75x39.3 mm hole).
  2. Switches 250V, 6A, for 19.1x12.1 mm holes - x2.
  3. Banana Plug Socket for max. D6.3 mm holes - x4.
  4. Wires applicable for 4A current - less than 1 meter.
  5. Little screws to fix the back cover, L5-10 mm, D2.5-3 mm - x4.
  6. AC-DC adapter such as for most modern laptops or monitors, 12V-5A recommended (optional).
  7. DC 12V 5.5x2.1 mm female socket to connect the AC-DC adapter (optional).

Print.

The photos show the “walls14” model that I printed, it means that it has 1.4 mm walls. I found that the sides with the vent holes are not as hard as I expected, at least when printed with PETG, this is why I also designed the “walls20” model that has 2.0 mm walls to replace my current model if/when I finally break it :) Please note that I did not print the “walls20” version yet, if you have any problems with it, please report.

Test and configure retract settings before printing - there will be a lot of retracts due to many vent holes in this model. The vent holes should be enough for passive cooling of the device, however, the producer of the ZK-4KX recommends to use an external fan if the current exceeds 3A during long periods. 

Print time is around 6 hours for the “walls14” model on Ender3V2 (it should be faster for direct drive printers due to shorter retracts). Plastic consumption is 40 grams.

Operation.

In mode 2 you can use not only AC-DC adapters but any power source with 5-30V voltage that you have at hand, for example four AA batteries or a car battery or maybe even a solar panel or a wind power generator… But some cheap USB adapters don't work with my XK-4KX because the input voltage drops below 4.8V under load and the device turns off. I think this device prefers input 5.5V or more for stable work.

Wiring.

 

License:

This model is free for personal use. Not for sale!

Final stuff.

Any questions → ask in the comments section. If you printed it, share the photos of your prints.

Tagi