MasterSpool Spacers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you have a spool holder that the wingnuts could snag on, this is your solution.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 336
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you have a spool holder that the wingnuts could snag on, this is your solution.
I recently purchased my first #MasterSpool from Rushmere 3D https://www.jays3dadventure.co.uk/Shop/index.php here in the UK.
I was concerned that my current spool holder could snag on the bolt heads or wing nuts, so I designed this to avoid any snags mid-print.
You don't even need to remove the bolts from your #MasterSpool, just loosen the wing nuts a little and the slots will slide under the bolt heads.
For the other side, if needed, I decided that a short cylinder would be easier when swapping refills.
If you print this, I'd appreciate it if you would post your make.
Thank you
Print instructions
Licence: Creative Commons - Attribution - Non-Commercial - Share Alike Category: 3D Printer Accessories Print Settings
Printer Brand: Creality
Printer: CR-10S
Rafts: No
Supports: No
Resolution: 0.2 - 0.32
Infill: 15%
Filament: 3D Printz UK PLA Green