1 / 4
Battery Base Tile and Torch
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Negative volume cutout for your slicer to add a torch + battery holder to an existing 2x2 (or larger) dungeon tile.
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 39
- Wydruki
- 1
- Wyświetlenia
- 469
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props & Terrains
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (32)Powiązane
Based on the Torch Wall model from the OpenForge project, use the negative STL in your slicer to cut out a spot for the battery holder, torch, access to the power switch, and a path for the wires to connect them.
BOM
- CR2032 coin cells
- CR2032 coin cell holders with power switch
- 3mm flickering LED
- 1/8" or 3mm heat shrink
Instructions
- Use “Torch and battery negative.stl” in your slicer as a negative volume to cut a space in your wall tile and print
- Print “3mm Torch.stl”
- Run battery holder leads through printed wall part out to torch cutout, trim to reasonable length to work with, and place a short length of shrink over at least one wire.
- Push the LED legs through the torch, solder long LED leg to red, short leg to black, and cover at least one joint with shrink.
- Pull torch into wall and press fit into place. Press fit battery holder into base bottom, it should be very tight. Stuff slack wire into wall.
- Drop a ball of hot glue on the LED and have fun making it look like fire