Ender 5S1 Ender Logo

This model can be slid into any bar of an Ender 5 S1.  I am not sure if it can fit onto any other printer.

These pieces can be printed separately by cutting them up in a modeling software or can be printed as one piece with supports. A very great way to attach the pieces together is with super glue. In your slicer, it must be noted that the widest part of the whole model, the part that fits into the aluminum extrusion must be 11-12 mm thick. I used an 11mm thick piece which leaves quite a bit of wiggle room, so I thought that 12mm could be ok.

Installation for Ender 5 S1

1. Remove 2 thick support screws with a large Allen Wrench (As Shown in Picture)
2. Remove the 4 inside screws with a smaller Allen Wrench (I don't think that this size Allen Wrench is included with the printer)
3. Carefully take the bar out and slide in the piece
4. Carefully put the bar back into the slot
5. Screw in all of the screws that were taken out into their respective places
6. Enjoy your new, fabulous Ender Logo