Angle brace for RC airplane
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An internal 90° angle brace for "foamie" RC airplanes using square foamboard tubes.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 129
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is an internal 90° angle brace for "foamie" RC airplanes using square foamboard tubes. In particular, I designed this piece for an Experimental Airlines Axon to keep the fuselage tubes square and prevent racking.
The braces weigh about 1.2 g each (PETG), and install easily with hot glue. A pair of braces will fit side-by-side (see photo) in a nominal 68-70 mm (external) square tube made of Dollar Tree foam board.
They also work as mini-bulkheads for mounting small components, and have three small holes for routing wires, pushrods, etc.
Print Settings
Printer:
Monoprice Maker Select
Rafts:
No
Supports:
No
Resolution:
0.25 mm
Infill:
100%
Notes:
I printed mine in PETG for extra resiliency, but ABS or PLA should work.
In Simplify3D, I set for 30% rectilinear infill with 2 perimeters, and 2 (each) solid top and bottom layers, but given the base dimensions, gap fill essentially makes it a 100% infilled part, weighing in at about 1.2 g.Post-Printing
Remove from the print bed, trim off any excess material, and install wherever 90° bracing is needed, using your adhesive of choice.
How I Designed This
Designed in Tinkercad.
Category: R/C Vehicles