Webcam holder for Aquila (Ender 3)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Webcam holder attached to printer frame using 2 M4 screws and T Nuts. I did design another holder that did not require…
- Ocena
- 4 / 5
- Polubienia
- 8
- Pobrania
- 60
- Wydruki
- 1
- Wyświetlenia
- 286
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Webcam holder attached to printer frame using 2 M4 screws and T Nuts.
I did design another holder that did not require screws but slid into the frame slots, however this could only be used at the back as it would require removing the mother board holder on the Aquila. If others are interested in this I could post as a separate design.
Print Settings
Printer:
Aquila (Ender 3)
Rafts:
No
Supports:
Yes
Resolution:
0.3mm
Infill:
30%
Filament:
Any Any (I used PLA+)Any
Notes:
I printed this upright (as shown in picture) with auto supports, overhang set to 60% so supports were only created for the screw holes. No supports were required for the rest of the holder.
I used a 10mm brim to improve bed adhesion.How I Designed This
Web cam holder designed in Blender.
Category: 3D Printer Accessories