Gridfinity supportless 1x1 bins with label and ramp.

I modeled some Gridfinity bins which will allow magnets to be press-fitted.

I added an internal ramp like I've had in some bins I've downloaded in the past which is very helpful in getting small parts out of the bottom of the bin. Keeping with the the theme of ‘multiples of 7’ the ramp has a 14mm radius.

I have also added a labeling shelf using the same approach - I have a label printer and the bins I got from the interwebs have just a hair too little space for the label, causing the bottom to peel up. The labels are 12mm in height, so a label shelf of 14mm with a 0.5mm fillet leaves just enough room for the label.

The ramp does not fit a 1u or 2u bin, so the ramped bins start at 3u and goes up to 12u.

Edit 11/14/2023: I found that a ramp with a 21 mm diameter is much easier to use on the deep bins, but they only work from 4u upwards, so I'm adding those.