Mantic Armada Ship Markers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Markers for putting next to a ship that needs to be removed from the board
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 233
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Miniature Gaming Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I created these ship markers after seeing someone online using a dice to mark where a ship was that needed to be moved in order for the turnkey to be used, because he had 2 ships next to each other.
It is based on the same principle as used in golf, where players use a coin or a golf ball marker to mark where their ball is if it needs to be removed for someone else to play their ball that may be in line with it.
So all you need to do if you are in this situation is:
Place the marker that is the same size as your ship on the side that is furthest away from the close ships. Then you can remove your ship, leaving the marker in place. Once the ship that needs to be turned has turned or moved away, you can replace your ship inside the marker. Finally remove the marker.
I have created an Bow-Aft marker if this is easier to use in some situations.
There are 2 types of markers. Set 1 uses a tab to lift it up and is slightly bigger in depth as well as height, compared to set 2.
Set 2 has a cut out, to be able to put a fingernail in it to pull it away from your ship. You can use either or both sets, it is up to you.
Do you want to be able to sell any or ALL of my prints shown here on Printables.com?
If so, then click on the 'buy me a coffee' link below, (or click here) and join one of my memberships. This gives you the option of a monthly, yearly or lifetime commercial license, along with a certificate and loyalty bonus models (both commercial and non-commercial). The non-commercial items are 3rd party models that may also interest you, all in one place.
The lifetime membership offers you unique commercial items not available to anyone else as well as all of the loyalty bonus models.
Please click the LIKE (Heart) Button if you like my models. If you REALLY like them, then please also buy me a coffee at the bottom of the page. Thank you.
Printing Instructions:
I printed these on my Creality CR-6 SE printer with Cura slicer 5.3.0 (Other printers/slicers can be used).
Material: PLA
Manufacturer: Prima Value
Colour: Light Grey
Resolution: 0.1 (First layer @ 0.2)
Nozzle: 0.4mm
Print Speed: 80mm/s
Nozzle Temperature: 210 Degrees
Bed Temperature: 65 Degrees
Infill: 10%
Supports: No
Skirt: No
Brim: No
Raft: Yes
Enjoy your prints.
https://www.buymeacoffee.com/tigertone
