1 / 5
K1 Max tilt open lid support — zdjęcie 1
1 / 5

K1 Max tilt open lid support

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tilt open your K1 Max top panel and use both hands for a quick work on the extruder.

Ocena
5 / 5
Polubienia
46
Pobrania
457
Wydruki
3
Wyświetlenia
2151
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Since I got my K1 Max I have had to seek for a place to put its lid for many times.
I was always afraid it will topple or fall and shatter so needed a solution for this.

First I got the holder to store the lid and print beds at the side from Big_Daddy.

But I wanted even more practical solution to be able to lift the lid for a moment and have both hands free to lock/unlock the extruder and load filament etc.

I got the idea from Hachimaki guy's model but I needed a bit higher clearence.

Also It would be nice to have permanent storage for this support. I probed the printer for feromagnetic parts and I found two model fan screws 105mm apart on the side:)
I used two 19x6x3 mm neodymium magnets I had at hand (ordered as 20x6x3). They are just strong enough to hold this part with mass 37g in place on those tiny screws.

I printed
PETG
0.4 nozzle
0.2 layer height
2 walls
10% gyroid infill 
Printed on side with organic supports for magnets' holes.

If you happen to use it, mind to keep the lid balanced and don't place this support too much to the front or back side of the side.

I got the idea from:
https://www.printables.com/model/536448-k1-max-spool-and-top-panel-holder

If I need to store the lid for longer I use:
https://www.printables.com/model/636944-k1-max-side-mounted-build-plate-glass-top

 

Tagi