1 / 21
Camaster Stinger I - Crosshairs and vacuum hose management — zdjęcie 1
1 / 21

Camaster Stinger I - Crosshairs and vacuum hose management

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A low budget crosshair for a Camaster Stinger I (CNC Router) Also includes vacuum hose management.

Ocena
0 / 5
Polubienia
0
Pobrania
12
Wydruki
0
Wyświetlenia
148
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

A low budget crosshair for a Camaster Stinger I (CNC Router) 
Also includes vacuum hose management. 

I purchased my very first CNC Router from Camaster, I got the Stinger I, but I didn't get the crosshair because I figure I didn't need it. After using my CNC enough times, I decided to make myself a budget crosshair :) 

This project costed me approximately $35 on parts, plus the 3D printed parts (178g of PCTG fillament) 

 

What you will need?

  1. Four M3 hex bolts and corresponding nuts. If you make a lot of 3D parts like I do, I suggest a pack of M3, like this one.
  2. Two lasers, here are the ones I used: 650nm red line laser module industrial laser module adjustable focus line length 19.7″ DC plug diameter 10mm (line-2pack)
  3. Two batter backs, here are the ones I used: Industrial DC socket Laser module DC battery holder box Removable battery holder box Can be connected to a power supply (excluding battery)(B-DC box-2pack)
  4. Two 16" long zip ties

A few things to note:

  • These lasers are not the best out there, the lines are thicker than I thought they would be, but they still get the job done. 
  • when you are aligning the lasers, make sure the laser line is center with the bit, I uploaded a picture showing the laser line thought the center of the bit. This is important! 
    • Make sure you use a thin bit for alignment, it is easier to determine the laser is centered. 
  • Make sure you do a good cable management, you don't want your cables to hang free.  
  • The hooks for the batter back aren't the best. The way they get printed make the layer adhesion to be fragile against the tension. Whenever I do this again, I will design them with a washer on the bottom to prevent layers from delaminating. 

If you like this project, please let me know. 

Thank you and happy printing. 

Tagi