1 / 5
200mm Fan Front with IO ports and Power Button for Fractal Node 304 — zdjęcie 1
1 / 5

200mm Fan Front with IO ports and Power Button for Fractal Node 304

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A custom front panel for the Node 304 for a 200mm fan, a power button, and IO ports.

Ocena
0 / 5
Polubienia
23
Pobrania
208
Wydruki
0
Wyświetlenia
3416
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

A custom front panel for the Node 304 case to support a 200mm fan, power button, and the IO ports that came with the case.

 

This is a remix of two other models in order to get the best of both:

https://www.printables.com/model/558286-fractal-node-304-better-cooling-front-cover-mod

https://www.printables.com/model/137181-200mm-fan-front-for-fractal-node-304

Parts:

Modification of the front of the case is necessary. See the pictures for how I modified mine (Also cut out the area along the red line to allow for the cables from the buttons and IO ports to pass through).

I had additional screws on the front to hold the fan in, but found that it was hard enough getting the nuts on the back of the countersunk screws along the edges and would have been impossible for the inner screw holes, so most of them have been removed in the uploaded version.

I had to drill out a larger hole for my power button, but I have increased the size of the hole to hopefully accommodate the 12mm power button better.

I have attached a piece of mesh to the front using magnets to catch dust and for ease of cleaning.

I printed in PETG with .2mm layer heights on a Prusa MK3S+. The corners of my front panel curled as I couldn't fit any brim due to the model taking the entire print bed. The print took about 14 hours.