Bar stock mount for Logitech C270 / Logitech C310
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter to mount Logitech camera on 1in bar stock. Should print without supports in either orientation. Part may be…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 258
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
Adapter to mount Logitech camera on 1in bar stock. Should print without supports in either orientation. Part may be mirrored to maintain center alignment when the camera is hanging.
Additional Materials Required:
M3 x 20
M3 Nut
1 in Wide 1/8 in Thick Aluminum Flat Bar https://www.homedepot.com/p/Everbilt-1-in-x-48-in-Aluminum-Flat-Bar-with-1-8-in-Thick-801927/204274000
Additional Motifications Pictured:
m12 Lens Mount for Logitech C270 https://www.thingiverse.com/thing:1376200
Logitech C270 Faceplate & Focus Knob https://www.thingiverse.com/thing:2972088
2.5mm Ultra-Wide Angle/M12 Thread Camera Lens https://www.amazon.com/gp/product/B07CZ5G2TY
All this came about because I wanted a stiffer mount for the octoprint cam on my Maker Select Plus / Wanhao i3. I drilled and bolted the bar stock to the carriage plate, bent up to a suitable position, and pushed the mount on the end of the bar stock. No additional fasteners required when mounted upright.
I purchased a Monoprice Mini Delta and wanted an octoprint camera for it too. The most suitable mounting placement for that printer was on top, hanging down. Friction fit didn't hold very long, so you will need to drill a hole through the mount and the bar for a bolt.
Category: 3D Printer Accessories