MagSafe Charger Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hide your cables with this smart MagSafe® Charger Stand
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 223
- Wydruki
- 1
- Wyświetlenia
- 1197
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is designed to fit the Apple MagSafe® Charger
I wanted a MagSafe® stand that hid the cable and kept my table relatively tidy. This stand allows for the cable to route through the stand's neck and out of the bottom, then be neatly routed through the back of the stand while being kept straight and level with the table.
It also allows for you to easily remove the original MagSafe® charger through a small hole in the back by pushing your finger through it.
I printed this on an AnkerMake M5 with PLA+, my settings were:
- Layer Height: 0.2mm
- Perimeters: 6
- Infill: 20% Gyroid
- Seam position: Back
- No supports
See the photos for visual instructions on how to feed your device's cable through and insert the charger into the stand.