1 / 2
Guitar tuner button — zdjęcie 1
1 / 2

Guitar tuner button

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fits 3.6x2.4mm shafts

Ocena
5 / 5
Polubienia
28
Pobrania
393
Wydruki
3
Wyświetlenia
1447
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Designed specially for Harley Benton locking tuners but may fit others if the shaft dimensions are the same (3.6x2.4mm). Looks good, but the reason was weight reduction of the headstock, as the guitar was very neck heavy. Less than 1 gram instead of 7 per button. It matters a lot as this weight was removed from a long lever.

Required a lot of iterations to achieve a tight fit. I attached a .step too for editing purposes.

Prints without supports standing as is in the STL. I printed them with 0.2mm QUALITY settings on a Prusa Mini+ in ASA, 6-6 top/bottom layers, 5 perimeters. Sanded them (mainly the top) with fine sandpaper to remove the layer lines, and finally came the acetone vapor smoothing. Be careful with acetone, read all the guides about this process!

Tagi