1 / 8
Teddy bank with a tophat as a key sliced for multi color — zdjęcie 1
1 / 8

Teddy bank with a tophat as a key sliced for multi color

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Teddy bank with a threaded opening and with a tophat as the key.

Ocena
0 / 5
Polubienia
5
Pobrania
35
Wydruki
0
Wyświetlenia
175
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Sculptures
Licencja
Creative Commons — Attribution — Noncommercial

I was thinking about creating a teddy for a while now and when I saw the piggybank contest I knew the time has come to make it into reality.

Features:

  • The design was split into 6 parts for multi color prints in mind (print the eye 2x so 7 parts total).
    • Head
    • Tophat
    • Threaded coinslot
    • Nose
    • Eye(s) print it 2x
    • Mouth
  • The threaded coinslot at the top can be opened with the tophat key.
  • The tophat can be used to hide the coinslot.
  • Based on experience a new tophat has been made. It's a 2 part print for increased strength and with an easy to replace pin.

Print settings:

  • Eye(s) / mouth
    • Material: Any (I used black PETG)
    • Layer height: 0.2 mm
    • Wall line count: 3
    • Infill: 25%
    • Support: No
    • Print in the downloaded orientation
  • Nose
    • Material: Any (I used black PETG)
    • Layer height: 0.2 mm
    • Wall line count: 3
    • Infill: 25%
    • Support: Yes - Tree support - Touching Buildplate
    • Print in the downloaded orientation with Support Overhang Angle: 75
  • Tophat
    • Material: Any (I used black PETG)
    • Layer height: 0.2 mm
    • Wall line count: 3
    • Infill: 15%
    • Support: Yes - Tree support - Touching Buildplate
    • Support Overhang Angle: 75
  • Head (in Cura)
    • Material: Any (I used orange PLA+)
    • Layer height: 0.2 mm
    • Wall line count: 3
    • Infill: 20%
    • Support: No
    • Fuzzy skin: Yes
    • Print in the downloaded orientation
    • Adequate cooling is advised for the best result
  • Threaded coinslot
    • Material: Any (I used orange PLA+)
    • Layer height: 0.2 mm
    • Wall line count: 3
    • Infill: 20%
    • Support: No
    • Fuzzy skin: No
    • Print in the downloaded orientation

Assembly:

  • The mouth was a snug fit for me but a tiny bit of glue can't hurt just to be sure
  • The eye(s) and the nose needs to be glued on
  • The coinslot can be threaded in using the hat as a key

I hope you like it! Let me know in the comments 😀

If you wish, you can buy me a coffee ☕

Tagi